C&C 33

Specifications

C&C 33 MkII             

Name................................................... Rogue’s Roost 1

Year...................................................................... 1986

Builder........................................................ C&C Yachts

Designer...................................................... Robert Ball

LOA...................................................................... 32’7”

LWL...................................................................... 26’2”

Beam.................................................................... 10’6”

Draft........................................................................ 6’4”

Displacement.................................................... 9,450lbs

Ballast.............................................................. 3,975lbs

Sail Area ...................................................... 511.25sqft

Hull ...............................................................Fiberglass

Deck............................................................. Fiberglass

Steering............................................................... Wheel

Keel.................................................................. Lead fin

Rudder................................................................ Spade

Fuel............................................... Aluminum tank 20gal

Water................................................................... 30gal

Hot Water............................................................... 6gal

Holding Tank......................................................... 25gal

Heat.................................. Dickenson Propane bulkhead

CONSTRUCTION

• The 33 Mk II is hand laid up fiberglass hull, using Isophthalic gelcoat resin, utilizing Balsa coring only in the forward portion of the topsides to add stiffness
• Instead of fully coring the hull, C&C used a reinforced Fiberglass structural grid to support loads from the mast and keel
• Deck is balsa cored and reinforced with solid fiberglass around fittings and fastners
• Hull-deck joint: inward facing flange, bonded and bolted through an aluminum tow rail

INTERIOR

• 1 cabin, 1 head plus a quarter berth
• Rich teak cabinetry in excellent condition
• Upholstery all in excellent condition
• Salon: two 6’ settees with a centerline table
• Port side folds open to form a double bed
• Storage lockers and shelving outboard
• Opening ports
• Chart Table: fwd facing table to port, with drawers
• AC/DC panel with breakers at the table
• Galley: L-shaped counters starboard aft
• Stove: Hillerange 3 burner plus oven
• Ice box: top loading
• Large single sink, hot and cold pressurized water
• V-Berth: traditional bed but with filler cushion, upholstery in excellent condition, large opening hatch, shelves
• Quarter berth: aft port side, reading lights, shelves
• Head: enclosed compartment forward port, vanity with sink, hot/cold pressurized water, mirrors
• manual Jabsco toilet, head to ocean or holding tank

MECHANICAL

• Yanmar 2GM20F diesel, 16hp, fresh water cooled
• Hours: 3527
• Direct drive, 1” Stainless steel shaft
• PSS Shaft seal (New 2025)
• Fresh water cooled (closed circuit)
• Prop: 3 Blade campbell Sailer, spare 2 blade
• Dripless shaft seal
• Heat exchanger serviced in 2019, new mixing elbow installed Jan 2026, new thermostat 2019

ELECTRICAL + PLUMBING

• Shorepower: 30amp/125volt
• 120VAC and 12VDC with circuit breakers and panel
• Battery switches: 2 x Perko rotary
• House Batteries: 2 x Canada-Proof, 6V, 242Ah (2022)
• Start Battery: 1 x Canada-Proof flooded, 12V (2022)
• Battery Charger: Phase Three model PT-25, 25amp
• Battery monitor: Xantrex LinkLite
• Battery isolator: Newmar
• AC Outlets, GFCI protected
• Solar panels: semi flexible with Vicron Smartsolar MPPT 75 charge controller (2022)
• Bilge pumps: Electric 800GPH with float switch
• Manual bilge pump
• Shower head extends from vanity sink, sump pump
• 2 x water tanks under settees, polyethylene
• 12V on demand freshwater pump
• Hot water, 6 gal tank, pressurized in head and galley
• manual Jabsco toilet, head to ocean or holding tank with macerator pump
• All new sanitation hoses in 2020
• Shower 12V sump pump
• Fresh water hand shower in the cockpit 
• Propane solenoid, 2 x aluminum tanks
• Marelon Ball valves

 INSTRUMENTS

• Chartplotter: Garman GPSMAP 943xsv (2022)
• Autopilot: Autohelm wheel pilot
• Depth: 
• VHF: Uniden UM380

 SAILS & CANVAS

• Mainsail: North Sails, Loose footed partially battened with lazy jacks
• Genoa: North Sails NPC Radian NorDac NDR 6.0 on a furler (2020)
• Gennaker in a sock 

STANDING RIGGING AND RUNNING RUGGING

• Masthead sloop
• Mast: keel stepped aluminum
• Double spreader, single backstay
• Standing rigging: Navtec rod 
• Primary winches: 2 x Barient #24 
• Coach roof winches: 2 x Barient #18
• Halyard winches: 2 x Barient #321 self tailing
• Clutches: 12 x Easylock
• All running rigging runs aft
• Furler: Harken 
• Mainsheet traveller
• Genoa tracks, pinstop adjustable

DECK GEAR AND COCKPIT

• Electric windlass: None
• Anchor: 10kg Rocna, 120ft chain and rope
• Double lifelines with side boarding gates (New Feb 2025)
• Very deep cockpit locker
• Edson binnacle with wheel
• Steering is cable and chain with pulley to quadrant
• Cockpit shower
• Folding swim ladder

ADDITIONAL EQUIPMENT

• Dinghy: 
• Outboard: Yamaha 2.5hp
• Navy Blue dodger
• Dickenson Spitfire BBQ mounted on the rail
• Cockpit table

MAINTENANCE

• Last haul out and bottom painted: Apr 2025
• Last zinc(s) change: April 2025
• Last engine oil change: June 2025 (included gearbox oil and fuel filters)
• Hull polish and wax: Apr 2024

Disclaimer

The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.